How To Remove Blood Stains On All Surfaces
April 12, 2011 by admin
Filed under Stain Removal Tips
Blood stains can be hard to remove since its hemoglobin compound binds with surfaces. Just like any other stain, it is easier to get rid of blood while it is still wet. Listed below is a basic guide on how to remove blood stains for various surfaces.
Clothing
If the stain is fresh, it can be removed by thoroughly washing it with cold water. If the stain is older, you can try soaking the cloth in a mixture of ammonia and a mild detergent. Scrubbing the cloth with a brush may also work, but make sure the fabric does not get ruined. Ammonia often leaves traces on dark clothing, so rinse well before laundering.
Stone
Dip a sponge in cold water to wipe off as much blood as you can. The blood may soak into the wood, so you will need to use a mixture of bleach, detergent, and water to get into the small cracks. Place the mixture on the marked area and cover it with a wet cloth to slow drying. Once the bleach has removed the stain, rinse down the surface and dry it.
Wood
Wood is an absorbent material, so removing an old blood stain is almost impossible. For new stains, you can try to wipe off as much as possible. Instead of changing the wood, trying adding a coat of wax or polish to hide the mark.
Fur
The same stain removal methods can be used for both synthetic and natural fur. Start by blotting the excess blood with a clean cloth. Place a few drops of ammonia in a cloth detergent and apply it to the area. Never scrub a fur surface or it may cause the material to get permanently damaged.
Leather
Cold water is usually used for removing stains, but leather will require lukewarm water since hot/cold temperatures can damage the surface. Mix in a mild soap and swish the water to create suds. Take the foam and apply it to the stained surface, be careful not to add too much water. After the mark is gone, immediately wipe the area dry.
Carpet
Rubbing stains in carpet will make the mark spread, so use a cloth to gently blot the area. Use an absorbent pad on the affected area and put pressure on it to draw out the liquid. Once the blood has been absorbed, use an ammonia/water mixture to remove any remaining marks.
